产品简介

Jetovator不来与它自己的电源和并且不要求至少180马力个人水上艺术经营。Jetovator改水推力方向从PWC的喷气机单位沿一个六十六个水管的到Jetovator自行车。这水推力然后用于推进和举起Jetovator入空气。车手能也改两前面喷管的水推力方向为了四面八方操纵Jetovator。PWC，提供力量，在Jetovator后跟随使用水管作为界限。它类似于象苏醒搭乘的其他水上运动辅助部件或除了辅助部件的滑水竞赛实际上拖曳小船而不是另一个方式。66只脚连接的水管附有PWC通过改喷气机推力方向180度对PWC的前面的一台由供应的被推的适配器。可以容易地安装和去除这台被推的适配器，允许PWC仍然使用作为法线。

标准Jetovator成套工具要求两人操作它；在控制高度的Jetovator的一个Jetovator的车手和方向和在控制引擎的节流孔的PWC的一个车手。虽然这也许听起来复杂，PWC的车手通常采取节流孔由大约80%全能力决定并且拿着它那里，直到Jetovator车手准备下来(再，非常类似于水橇或wakeboarding)。

英文介绍

The Jetovator does not come with its own power source and and requires a minimum of 180 hp personal water craft to operate. The Jetovator redirects the water thrust from the jet unit of the PWC along a sixty-six hose to the Jetovator bike. This water thrust is then used to propel and elevate the Jetovator into the air. The rider can also redirect the water thrust of the two front nozzles in order to maneuver the Jetovator in all directions.The PWC, which provides the power, follows behind the Jetovator using the hose as a tether. It is similar to other water sports accessories like wake boarding or water skiing except the accessory is actually towing the boat rather than the other way around. The 66 foot connecting hose is attached to the PWC via a supplied thrust adapter that re-directs the jet thrust 180 degrees to the front of the PWC. This thrust adapter can be easily installed and removed, allowing the PWC to still be used as normal.

The standard Jetovator kit requires two people to operate it; a rider on the Jetovator controlling the height, and direction of the Jetovator, and a rider on the PWC controlling the throttle of the engine. Although this might sound complicated, generally the rider of the PWC just takes the throttle up to approximately 80% of full power and holds it there until the Jetovator rider is ready to come down (again, very similar to waterskiing or wakeboarding).